HD-021 Serrated Black Front Sight - .200"

Dear Harrison Design:

My order number 38XXX arrived today and I felt that I must compliment you on selling and delivering a high quality product. I ordered the front sight for a 2020 Python, your part number HD-021, to address an issue with my Python shooting high even with the rear sight bottomed out.  I read that your sights were taller than the stock Colt sight and decided to see if your product would address my issue.

You shipped my order immediately, it arrived quickly and packaged properly to protect the contents and best of all it fits perfectly and is exactly as you described it on your website. Also the quality of finish and machine work is excellent.

Thank you for selling and delivering a fine product. That is a true rarity today unfortunately.  I  will recommend your product to several of my friends that have new Colts, and also to the gunsmith at the local gunshop that I frequent.

Cordially

John H

I have a 4 and a 6 inch 2020 Anaconda. On both guns, the front sight is too low. On the 6 inch gun, I put a Vortex Venom so the front sight was a non-issue. The 4 inch gun arrived on a Thursday. It printed six inches high; by the next Monday,  four days later, John’s front sight was on my gun.  With the rear sight bottomed out, and the new front sight, I hit a 2 inch black dot 4 out of 5 times, using the “Pumpkin on a Post” hold. The distance: 27yards, braced, sitting (Elmer Kieth style). My projectile of choice is a Lyman 429421 that I cast, over a full charge of AA#9. Meanwhile, back to the front sight, It did get me on target, but with no room to spare. The factory rear sight is completely bottomed out. On the plus side, I have in effect, a zero stop rear sight, which is cool. On the negative side, there is no room for error, nor can I shoot a heavier,  slower projectile and still be correct for elevation. So basically I have a fixed sight gun that is zeroed for my favorite load which isn’t necessarily a bad thing.
John’s sight is a thing of beauty. It looks factory. The bottom line is: It works within my parameters. Two thumbs up, Buy one (heck, buy more!)
But if the sight was .025” taller, it’d be better still because the “Window of Adjustability “ would be greater.
** Anacondas Rock! Get one.
***John is a fine Southern Gentleman. A#1 kind of guy. Buy with confidence.

Thanks for listening, RJ

With this front sight, a full charge of AA#9, and a 240 XTP (Very accurate and fast load, BTW) my Four inch Anaconda is Dead On at 30 yards both elevation and wind age.
This front sight is well worth the money.
RJ